Is it bad to over torque caliper bolts
Also, some bracket bolts can be torque-to-yield or require liquid tread lockers. 7. Over torquing the caliper guide pin bolts: Caliper guide pin bolts typically need a 13mm wrench to remove. It is a rookie mistake to go nuts on these bolts and break the heads off.13 May 2013
Can you over torque caliper bolts
As for the caliper, it's also good technique to use a torque wrench. The main reason is so you don't over-tighten then, which might strip out the housing the bolt goes into, or ruin the mounting bolt in the first place.11 May 2018
How tight should I tighten my caliper bolts
Because caliper bolts MUST stay on, they need a LOT of torque. AutoZone, for example, recommends 113 pound feet of torque. To put that number in perspective, the average person can, according to NASA, apply about 15 pound feet with a bare hand.
How tight should caliper pin bolts be
Snug is fine. Caliper bolts are loaded in SHEAR, which means a force they experience is trying to cut them off as if they were being decapitated. The tightness of the bolt IS important, but not as important as the strength of the bolt to resist the shear forces.
How tight should caliper bracket bolts be
These bolts typically need just 25 to 35 ft/lbs of torque. Take it easy!
Do I really need a torque wrench for brakes
I would recommend the use of a torque wrench on these fasteners if, for some reason, you are physically impaired somehow that your ability to tighten a fastener or to sense how much you've tightened it is impacted, such as bad arthritis or a pinched nerve causing numbness or pain, or possibly having had to load up on …
Should you put thread lock on caliper bolts
No man don't use thread locker if you're reusing the bolts. Just make sure the threads aren't damaged, clean of dirty stuff use a bit of anti-seize and torque to specs.21 Sept 2014
Should you put anti seize on caliper bolts
Anti seize is no good for slide pins, it tends to solidify and not do its job very well for what it needs to to. I use a dab of blue loctite on the bracket bolts and a leave the caliper bolt threads dry. Never had an issue with those seizing, even in PA.21 Sept 2020
Can you over tighten caliper bracket bolts
Over torquing the caliper guide pin bolts: Caliper guide pin bolts typically need a 13mm wrench to remove. It is a rookie mistake to go nuts on these bolts and break the heads off. Typically these bolts require only 25- to 35-ft/lbs of torque. Be gentle!13 May 2013
How tight should bike calipers be
The clearest giveaway that something is wrong with your brakes is if the brake lever is too tight or too loose. If the lever touches the handlebars, the brake cable is too loose. If you can barely squeeze it at all, the cable is too tight. Ideally, the brake lever should squeeze 3-4cm before becoming difficult.24 Jul 2020